RACE PART SOLUTIONS 561-375-6277

Shopping Cart
0 items - $0.00

HSP-180020 #1

Sticky Heat Shield 1/8 X 12 X 23 In

HEAT SHIELD PRODUCTS  |  Part# HSP-180020


In Stock


Highlights:

  • Add-On Part - NA
  • Title - Peel and Stick Heat Shield

MADE FROM CERAMIC INSULATION SHIELDED BY A RUGGED LAYER OF ALUMINUM, HP STICKY SHIELD MAY BE PRESSURE WASHED AFTER INSTALLATION AND IS RESISTANT TO THE ELEMENTS. WITH 1 INCH OR MORE AIRSPACE, SHIELDS UP 90 PERCENT OF RADIANT HEAT AWAY.

$51.39


 





HP Sticky Shield is the ultimate way to stop heat from radiating into the drivers compartment of your ride. Made from a dense layer of 1/8? fiberglass insulation shielded by a rugged layer of .003? thick aluminum, HP Sticky Shield may be cleaned after installation and is resistant to the elements. The heavy duty peel and stick adhesive will bond to almost any clean surface (not recommended for unfinished fiberglass or carbon). It is the perfect radiant heat shield for transmission tunnels, mufflers, catalytic converters, DPF?s, turbos, downpipes, and exhaust system heat. This HP Sticky Shield can be used with less than 1? of airspace, however when used with 1? or more airspace, it is capable of shielding over 90% of heat. Did that set of long tube headers on your Mustang, Camaro, Challenger, or tuner move your catalytic converter where there are not any factory heat shields? Use Sticky Shield to stop the heat! That Jeep getting some serious heat in the transmission tunnel or from the cat, Sticky Shield it away!



Categorized under:
  · Heat Insulating Products » Heat Shield