Maven -10 Mid Frame Turbo Mount
MAVEN PERFORMANCE PRODUCTS | Part# MAV-TMMF-10
In Stock
Billet Turbo Oil Drain Flange And Mount For Mid Frame Turbo With -10 Orb Thread
$139.00
The mid frame turbo mount- a small percentage actually have to open the bolt "through" holes and usually only if its an older turbo but there are a few exceptions. The Bullseye NLX version comes with the larger bolt holes as that is standard on that turbo.
FEATURES:
Designed & machined in the USA
Billet Cold Rolled Steel (CRS)
Dual tube diameter Pockets- 1 inch & 1-1/8 inch
Can also butt weld 1.25" tubing to it
Center mount turbo for minimum flex
-10 ORB/AN drain
O-ring seal - no gasket required
Bearing housing can pivot 360 degrees
Weighs 1 LB
Measures 4.4 inches L x 1.4 inches W x 1.25 inches H
THE MAVEN PERFORMANCE BILLET STEEL TURBO MOUNT SUPPORTS THE TURBO FROM THE BEARING HOUSING AT THE DRAIN INTERFACE. THIS MOUNT WAS DESIGNED SPECIFICALLY FOR MID-FRAME TURBOCHARGERS SUCH AS THE BORG WARNER S400 series, GTX5533R, GTX5518R AND MANY OTHERS- WE ALSO OFFER A VARIATION FOR THE BULLSEYE NLX WITH THE BILLET ALUMINUM CENTER (SELECT THIS MOD IN THE PULL DOWN)
FEATURES:
Designed & machined in the USA
Billet Cold Rolled Steel (CRS)
Dual tube diameter Pockets- 1 inch & 1-1/8 inch
Can also butt weld 1.25" tubing to it
Center mount turbo for minimum flex
-10 ORB/AN drain
O-ring seal - no gasket required
Bearing housing can pivot 360 degrees
Weighs 1 LB
Measures 4.4 inches L x 1.4 inches W x 1.25 inches H
THE MAVEN PERFORMANCE BILLET STEEL TURBO MOUNT SUPPORTS THE TURBO FROM THE BEARING HOUSING AT THE DRAIN INTERFACE. THIS MOUNT WAS DESIGNED SPECIFICALLY FOR MID-FRAME TURBOCHARGERS SUCH AS THE BORG WARNER S400 series, GTX5533R, GTX5518R AND MANY OTHERS- WE ALSO OFFER A VARIATION FOR THE BULLSEYE NLX WITH THE BILLET ALUMINUM CENTER (SELECT THIS MOD IN THE PULL DOWN)